The 'Right Now' Printable Upgrades

I printed several on the Mini Delta:

  • Z-Axis spacer - Properly position the z-axis motor. Done during assembly.
  • Cable clips for the display cable - keep the cable from flopping around.
  • Filament guide at the extruder - keep your filament away from the Z-axis screw.
  • SD Card Holder - A place to mount that micro SD to full SD adapter cable that I ordered. I hate handling micro SD cards and it's easy to insert a micro SD card into the guts of the case instead of the socket.
These I had to print on the Ender 3 itself:
  • Fan Shroud - keep the junk out of the electronics box.
  • Display back cover - what were they thinking leaving the back of the display board so exposed? Extra tip - a piece of tape over the beeper quiets it a lot!
  • Filament guide at the top rail - route the filament out away from the frame so it comes into the extruder below at a better angle.
All of the above are upgrades I considered high priority. Not all really are but most were easy to print and solved some problem or other.